Alamo 60C Operator's Manual del operador descargar pdf (Pagina 44)

ASSEMBLY

BH20 Series 04/13 Assembly Section 3-4

ASSEMBLY

SETUP INSTRUCTIONS - SHIELDING AND DEFLECTORS

Bush Hog BH20 Series models as shipped from the factory, have all Shielding and Deflectors in place. Dealer

should inspect to make sure that all Safety Shielding and Deflectors are in place and fasteners are tight

Front and Rear Deflectors or Front and Rear Chains are a selection on BH25, BH26, BH27

Models. One typ

e of guard must be installed (and maintained in good repair) except for

agricultural purposes only in areas where persons, vehicles, livestock, or other property will

not be endangered by thrown objects and where such safety equipment would prevent the

mower's reasonable performance of its assigned agricultural task.

Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will

provide protection from thrown objects with proper operation under normal conditions. Deflectors must be

maintained in good repair or replaced after no more than two inches of wear off lower edge.

SETUP INSTRUCTIONS - TAILWHEEL

Bush Hog BH20 Series models as shipped from the factory Tailwheel Frame and Tailwheel mounted to the

unit.

ADJUSTING FOR WORK

The cutter should be operated at the highest position which will give desired cutting results. This will help

prevent the blades from striking the ground, reducing blade wear and undue strain on the machine. For best

results under heavier cutting conditions, always tilt the cutter approximately 2 inches (51mm) lower in the front.

This tilt decreases horsepower requirements and increases potential ground speed. When fine shredding is

desired, adjust cutter deck level or slightly lower in the rear. This will keep the foliage under cutter until

thoroughly shredded. More power is required for shredding. Each cutter can be adjusted to several cutting

heights. The BH20 Series Models can be adjusted from 1-1/2" to 10-1/2” of cutting height.

To adjust, ra

ise cutter and block securely in position. Remove bolt from adjusting bracket shown in Figure

below. Adjust tailwheel frame up or down and secure in desired position.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 137 138

Sin comentarios

Alamo 60C Operator's Manual del operador Pagina 44